APlusLift 10k lbs Falcon Single Release Car 2-Post Lift #TR-10C, TR-10CX
Couldn't load pickup availability
APlusLift Shipping
Equipment: Call for shipping
Parts: Standard tiered rate
Meets the highest safety standards set by the Automotive Lift Institute.
| Model / Part Number | TR-10C / TR-10CX |
| Capacity | 10,000 lbs |
| ALI Certified | Yes — Gold Label (source: apluslift.com) |
| Lift Type | Overhead direct-drive 2-post lift (ALI Gold Label certified) |
| Lock Release / Configuration | Single-point release, 3-stage front and rear arms |
| Overall Height | 143 3/4" (TR-10C) / 166" (TR-10CX) |
| Overall Width | 140 7/16", 146 3/8", or 152 1/4" (three selectable widths) |
| Inside Columns | See width configuration |
| Drive-Thru Clearance | 88 1/8", 94 1/16", or 100" (matches width setting) |
| Max Lift Height | See model configuration |
| Rise Time | About 50 seconds |
| Included Adapters | 1 1/2", 3", and 6" adapter sets |
| Motor / Electrical | 220V, 1-phase, 3 HP, 30A breaker recommended |
| Hydraulic Oil | AW32 or AW46 hydraulic oil |
| Concrete Requirement | 6" thick, 3500 PSI reinforced concrete (4" allowed for vehicles 9,000 lbs and below) |
| Shipping Weight | 2,000 lbs (TR-10C) + 200 lb height extension (TR-10CX) |
| Warranty | 3 years / 36 months (source: apluslift.com) |
- 6" thick, 3500 PSI reinforced concrete (4" allowed for vehicles 9,000 lbs and below)
- Must be fully cured before anchor installation
- 220V, 1-phase, 3 HP, 30A breaker recommended
- Dedicated circuit recommended
- Have an electrician run a drop to the bay before install day
- Plan for 143 3/4" (TR-10C) / 166" (TR-10CX) overall lift height
- Floor width 140 7/16", 146 3/8", or 152 1/4" (three selectable widths)
- Measure to lowest obstruction, not peak
APlusLift TR-10C / TR-10CX — 10,000 lbs 2-Post Lift
A lot of shops skip ALI certification because it adds cost and they assume their lift will pass inspection regardless. But if your shop works on insurance repairs, serves a dealership customer base, or operates in a state where annual lift inspections are standard, an uncertified lift is a liability exposure that a low price tag does not offset. The APlusLift Falcon TR-10C is the 10,000 lb 2-post lift for buyers who want ALI Gold Label certification without moving into a premium Challenger or Stratus price bracket — documented third-party certification, 3-stage arms, three adapter sets, and two height configurations in one package.
The TR-10C is available in standard and extended-height TR-10CX configurations, and comes with three selectable drive-thru widths (88 1/8", 94 1/16", or 100") so you can tune the install to your bay rather than adapting your bay to the lift. The 3-stage front and rear arms reach a wider range of pickup points than a standard 2-stage layout, and the 50-second rise time keeps the bay moving. The 6" 3500 PSI concrete requirement is consistent with other commercial-grade 10K lifts — Alamo confirms your slab before delivery.
Who the TR-10C / TR-10CX Is Built For
- Shops that work on insurance or fleet accounts where the adjuster, inspector, or client asks for ALI-certified equipment — the TR-10C's Gold Label certification is a documented answer that protects you in that conversation.
- Independent shops in states with periodic lift inspections — an ALI-certified lift starts every inspection from a verified baseline instead of putting the inspector in a position of determining compliance on the spot.
- Technicians who work across a wide range of vehicles from compact sedans to light trucks — the 3-stage arms cover more pickup-point positions than a 2-stage layout, reducing the need to reposition the lift for different vehicle profiles.
- Shops with variable ceiling heights or width-constrained bays — the TR-10C's three selectable drive-thru widths and two height configurations (TR-10C standard, TR-10CX extended) let you fit the lift to the space rather than the reverse.
- Value-conscious buyers who want ALI certification at an APlusLift price point — the Falcon TR-10C gives the certification without requiring the budget for a Challenger CL10AV3 or Stratus SAE-C10A.
- High-volume general service shops that lift 20 or more vehicles per week and want the assurance that every lift cycle is backed by a certified load rating — the Gold Label means that 10,000 lb number is third-party verified, not manufacturer-claimed.
What the TR-10C / TR-10CX Is NOT Built For
- ❌ Shops needing more than 10,000 lb capacity — step up to the APlusLift AP-14SR or AP-20SR
- ❌ Operations where ALI certification is irrelevant and a basic 10K overhead lift at a lower price point is sufficient
What Makes the TR-10C / TR-10CX Different
ALI Gold Label Certification — Third-Party Verified
The Falcon TR-10C carries ALI Gold Label certification, verified through the Automotive Lift Institute's published certified-products database. That means the 10,000 lb rating is not a manufacturer claim — it is a third-party validated load capacity backed by documented testing. For shops that work with insurers, fleet managers, or inspection programs, the Gold Label is the difference between a lift that passes review on paper and one that requires a conversation. The certification is tied to this specific model and verified at apluslift.com.
3-Stage Arms for Broader Pickup Point Coverage
The TR-10C's 3-stage front and rear arms extend further than a standard 2-stage design, which matters when your shop mixes compact cars, mid-size SUVs, and light trucks across the same lift. More reach means fewer situations where you need to reposition the vehicle or reach for an extension block. The three included adapter sets — 1 1/2", 3", and 6" heights — pair with the 3-stage arms to give you a wide lift profile that handles most vehicles in the shop's daily mix without additional accessory orders.
Three Width Settings, Two Height Configurations
The TR-10C is available in three selectable drive-thru widths: 88 1/8", 94 1/16", and 100" — so you tune the lift to your bay's constraints instead of rebuilding around the lift. For shops with tighter column spacing or wider bay doors, the width selection is real flexibility. The TR-10CX extended-height configuration (166" overall vs. 143 3/4" standard) gives ceiling-constrained shops a path to the taller clearance they need for trucks and tall SUVs. Alamo helps you select the right configuration at time of order.
50-Second Rise Time for Production Pace
At about 50 seconds from ground to full height, the TR-10C is faster than the 75-second rise time on the larger AP-20SR and AP-14SR models in the APlusLift lineup. In a shop lifting 15 or more vehicles a day, that 25-second difference adds up across shifts. The overhead direct-drive design delivers that rise time without the maintenance overhead of a chain-drive system — consistent, clean hydraulic power from the 3 HP, 220V motor.
3-Year Warranty on an ALI-Certified Platform
The TR-10C carries APlusLift's 3-year / 36-month warranty alongside its ALI Gold Label certification — two coverage points that, together, represent the most documented value in a 10K 2-post lift at this price. Warranty service runs through Alamo Equipment & Service, not a third-party service network. If the hydraulics, the release mechanism, or any component needs attention within the coverage window, you call the same team that sold and installed the lift — no case numbers, no transfer queues.
- ✅ Shops working on insurance or fleet accounts where the adjuster or inspector requires ALI-certified equipment documentation
- ✅ Independent shops in states with periodic lift inspections — ALI certification provides a verified baseline before the inspector arrives
- ✅ Techs servicing a wide range of vehicles — the 3-stage arms cover more pickup-point positions than a standard 2-stage layout
- ✅ Shops with variable ceiling heights or width-constrained bays needing three selectable widths and two height configurations
- ✅ Value-conscious buyers who want ALI certification at an APlusLift price point without paying for a Challenger CL10AV3
- ✅ High-volume general service shops where the 50-second rise time and certified load rating support a fast, documented workflow
- ❌ Shops needing more than 10,000 lb capacity — step up to the APlusLift AP-14SR or AP-20SR
- ❌ Operations where ALI certification is irrelevant and a basic 10K overhead lift at a lower price point is sufficient
TR-10C / TR-10CX vs. Challenger CL10AV3 (10,000 lb Versymmetric) — Which Lift Is Right for Your Shop?
| Decision Point | TR-10C / TR-10CX | Challenger CL10AV3 (10,000 lb Versymmetric) |
|---|---|---|
| Capacity | 10,000 lbs | 10,000 lbs |
| ALI Certified | Yes (Gold Label) | Yes (Gold Label) |
| Arm design | 3-stage front & rear | Versymmetric (sym/asym) |
| Drive-thru widths | 3 selectable | Adjustable |
| Best fit | ALI certified value — APlusLift price | ALI certified with sym/asym flexibility — Challenger premium |
Choose the TR-10C for ALI Gold Label certification at a value APlusLift price point with 3-stage arms. Choose the Challenger CL10AV3 when Versymmetric symmetric/asymmetric arm flexibility is the priority. Both stay inside Alamo’s catalog — call (844) 480-6059.
Full Specifications — TR-10C / TR-10CX
| Model / Part Number | TR-10C / TR-10CX |
| Capacity | 10,000 lbs |
| ALI Certified | Yes — Gold Label (source: apluslift.com) |
| Lift Type | Overhead direct-drive 2-post lift (ALI Gold Label certified) |
| Lock Release / Configuration | Single-point release, 3-stage front and rear arms |
| Overall Height | 143 3/4" (TR-10C) / 166" (TR-10CX) |
| Overall Width | 140 7/16", 146 3/8", or 152 1/4" (three selectable widths) |
| Inside Columns | See width configuration |
| Drive-Thru Clearance | 88 1/8", 94 1/16", or 100" (matches width setting) |
| Max Lift Height | See model configuration |
| Rise Time | About 50 seconds |
| Included Adapters | 1 1/2", 3", and 6" adapter sets |
| Motor / Electrical | 220V, 1-phase, 3 HP, 30A breaker recommended |
| Hydraulic Oil | AW32 or AW46 hydraulic oil |
| Concrete Requirement | 6" thick, 3500 PSI reinforced concrete (4" allowed for vehicles 9,000 lbs and below) |
| Shipping Weight | 2,000 lbs (TR-10C) + 200 lb height extension (TR-10CX) |
| Warranty | 3 years / 36 months (source: apluslift.com) |
⚠️ Installation Requirements
- Ceiling height: Plan for 143 3/4" (TR-10C) / 166" (TR-10CX) overall lift height; measure to the lowest obstruction.
- Electrical: 220V, 1-phase, 3 HP, 30A breaker recommended; consult an electrician for exact breaker sizing.
- Concrete: 6" thick, 3500 PSI reinforced concrete (4" allowed for vehicles 9,000 lbs and below); must be fully cured before anchoring.
- Bay width: Confirm 140 7/16", 146 3/8", or 152 1/4" (three selectable widths) floor width clearance; measure before ordering.
- Hydraulic oil: AW32 or AW46 hydraulic oil.
- Surface anchoring: Lift must be anchored per manufacturer specification — do not skip anchoring on production bays.
- Installation: Alamo installs every lift we sell. Call (844) 480-6059 to schedule.
APlusLift Warranty — TR-10C / TR-10CX
APlusLift backs the TR-10C / TR-10CX with a 3-year / 36-month limited warranty (source: apluslift.com). Confirm component-level coverage terms at purchase.
| Component | Coverage Term |
|---|---|
| Parts | 3 years (car lift parts warranty, per apluslift.com) |
| Wear items (pads, rubber, cables) | Consumables not typically covered under limited warranty |
Warranty service is through Alamo Equipment & Service. When you buy from us, you are not waiting on a manufacturer hotline — call (844) 480-6059 and we handle it. APlusLift car lifts carry a 3-year parts warranty; confirm any extended or component-specific terms at purchase.
Frequently Asked Questions — APlusLift TR-10C / TR-10CX
Why Buy the TR-10C / TR-10CX from Alamo Equipment & Service?
- We install it. ALI certification covers the lift as manufactured — proper anchoring and installation are what keep it certified in your bay. Alamo's install team handles the anchor placement and setup so the certification means something from day one.
- We service it. If anything needs attention on the TR-10C after install, call Alamo at (844) 480-6059 — the same team that installed it, not a generic manufacturer service line.
- We size it with you. The TR-10C offers three drive-thru widths and two column heights — Alamo walks through your bay dimensions and vehicle mix to recommend the right configuration before you order.
- Free shipping. The TR-10C ships free to the 48 contiguous states.
- Expert comparison help. If the Challenger CL10AV3 (ALI certified Versymmetric 10K) is a better fit for your shop's arm geometry preference, Alamo will tell you before you buy.
A shop buying from a pure e-commerce retailer gets a box. A shop buying from Alamo gets a partner.
Shipping Information:
Customers may pick up their lift at the nearest freight terminal at no additional cost.
You will need to provide your own trailer. Terminal staff will safely load the lift onto your trailer. The RECEIVER/CUSTOMER is solely responsible for properly securing the load for transport.
To schedule a pickup, contact us at info@alamoequipment.com or
(844) 480-6059. Please include the lift model and your zip code so we can direct you to the appropriate terminal.
Warranty Information
- 3-Year Structural Components Warranty
- 1-year Parts Warranty
Buy in bulk
| Variant | Quantity | Price | Total |
|---|---|---|---|
|
12 Feet Tall - TR-10C
ALMAPLTR10C
|
|
||
|
14 Feet Tall - TR-10CX
ALMAPLTR10CX
|
|
Product subtotal
