FS-Curtis CT7.5 80G Vertical 7.5HP Two-Stage Simplex Air Comp #CT7.5-V

FS-Curtis CT7.5-V — 7.5 HP Air Compressor

A shop running a 5 HP compressor that can't keep up when two or three techs pull air at once is stuck picking between a small upgrade and a big one — and if the building's already wired for 575V, most 7.5 HP compressors on the market won't even plug in without an added step-down transformer.

The FS-Curtis CT7.5-V is a two-stage reciprocating compressor rated for 7.5 HP with an 80 gallon vertical ASME tank, built for shops and commercial operations that need compressed air on tap all day without paying for accessories they don’t need.

Who the CT7.5-V Is Built For

• ✅ A shop with 575V three-phase wiring already in the building that's outgrown a 5 HP compressor and needs the CT line's 7.5 HP step-up without a voltage-conversion headache
• ✅ A multi-tech shop where 2-3 techs pulling air simultaneously during a busy shift have already run a 5 HP unit's tank dry mid-job, needing the extra CFM to stop that from happening
• ✅ An owner who's been quoted a step-down transformer just to run a standard 7.5 HP unit on 575V service, and would rather buy equipment that matches the panel already installed
• ✅ A shop standardizing on the CT line specifically because a CT5-V already runs reliably at another bay and the crew knows the maintenance routine
• ✅ A shop with a narrow bay or tight wall space where the vertical tank's smaller floor footprint matters even at the 7.5 HP tier

What the CT7.5-V Is NOT Built For

• ❌ Home garages or single-bay use — a 5 HP or smaller unit is more cost-effective for lighter demand
• ❌ Shops needing more than roughly 24-25 CFM continuous or wanting redundancy — look at the CT10-H or a duplex CA unit instead
• ❌ Buyers wanting factory auto-drain/dryer accessories standard — not available in this configuration

What Makes the CT7.5-V Different

Commercial 2-Stage Pump

The CT7.5-V uses a C75, Cast-Iron, Two-Stage pump built for daily, all-day duty cycles — not a hobby-grade single-stage unit that struggles under continuous shop use.

CFM & Pressure Output

Delivers 24.2 CFM @ 175 PSI and holds pressure up to 175 PSI, enough headroom to run impact wrenches, tire equipment, and paint tools without the tank running dry.

Power Requirements

Single or Three-Phase, 230V/460V/575V options available. Confirm your panel and breaker sizing with an electrician before delivery.

Full Specifications — CT7.5-V

FS-Curtis Warranty — CT7.5-V

FS-Curtis backs the CT7.5-V with a 1-year parts-only warranty.

Warranty service is through Alamo Equipment & Service — call (844) 480-6059 instead of waiting on a manufacturer hotline. Coverage is subject to FS-Curtis warranty terms, conditions, and requirements.